Orangery walk-through

30 x 60 ft room. 6 motorized glass doors, 3 per side in bays 3 to 5. Each door rolls up the wall, around a short bend, then up under the roof slope.

Doors

Open runs to the top on one push. Close only moves while you hold the button down (hold-to-run, UL 325).

All 6 doors

Speed

Real time is about 1 ft/s up and 0.75 ft/s down, so about 12 s to open and 16 s to close.

Views

Drag to orbit, right drag to pan, scroll to zoom. Section cuts the building through the middle of the bay 4 doors and looks east.

Walk around

W A S D or arrow keys to move, Shift to hurry, drag the view to look around. Glass walls stop you. Walk out through a door once it is up past head height, or out the west double doors to the patio.

Doors in the 3D view: tap a door (or press E near its push button) to open it. Press and hold to close it; it only moves while you hold.

Show

Lantern vents (automatic)

18 awning windows along the top of the ridge lantern, 9 per side. Each is hinged at the top and its bottom swings out, up to 35 degrees. In Auto a thermostat runs them.

Inside temperature
Wind

Auto starts opening at 72 F and is full open at 80 F. Rain closes them in Auto. Wind over 25 mph closes them in any mode. A full stroke takes about 60 s (15 s at 4x).

MEP

Concept R1 mechanical, plumbing and gas layer, bridging from the building to the HVAC and plumbing drawings. Click a colored item in the 3D view for its tag.

Heating: tube heaters, burners, flues, wing wall heaters
Gas: propane tank, regulator, piping
Water: service, water heater, fixture supply, hose bibs
Waste and vent: drain to septic, vent stack
Air: fans, evap cooler and supply duct, exhaust, lantern vents, airflow
Future mini-splits (rough-in only, translucent)

Decided 9/30: farm well water, propane, bottle filler by the toilet rooms, 3-comp sink in staging. Assumed: ventless oven (no Type I hood). Open: county plan review for staging, toilet count for 99. Concept R1, not for construction.

Legend

Glass door sections (4 per door)
Fixed glass (bays 1, 2, 6)
Track, frame, motor
Photo eye beam (lit while closing)
Infrared tube heater
Push-button station (on the post)

Door numbers

Geometry matches the Blender model (design_c.py). Door weight, motor and exact track are for the door maker to confirm in the RFQ.